Page 3 of 3 FirstFirst 123
Results 21 to 26 of 26

Thread: New Michigan Member

  1. #21
    SEC Member
    Join Date
    May 2015
    Location
    Detroit, USA
    Posts
    65
    Rep Power
    9

    Re: New Michigan Member

    Unfortunately I cant help much on the dimensions of the Ferrari motor just yet as its completely torn apart. I'm sure there are others on the forum than can help though. The engine bay is quite small as is the F. motor and the Alfa. Hemi could be a problem due both to its mass (these cars a squirly enough already) and the width across the cylinder-heads. Be an interesting project though. What would you do for a gearbox?

  2. #22
    Free user
    Join Date
    Feb 2017
    Location
    Michigan
    Posts
    40
    Rep Power
    0

    Re: New Michigan Member

    Yeah. I'm pretty sure I'm gonna do a turbo i4. The HEMI is too big but being a Chrysler engineer we are constantly trying to HEMI everything. =)

    I could still use the height and width of the engine bay frame rails though. =)

  3. #23
    Free user
    Join Date
    Oct 2011
    Location
    united states
    Posts
    334
    Rep Power
    0

    Re: New Michigan Member

    i will try to measure tonite.

  4. #24
    Free user
    Join Date
    Feb 2017
    Location
    Michigan
    Posts
    40
    Rep Power
    0

    Re: New Michigan Member

    any progress?

  5. #25
    Free user
    Join Date
    Oct 2011
    Location
    united states
    Posts
    334
    Rep Power
    0

    Re: New Michigan Member

    Yes, sorry about the wait. I have been crazy sick for the last month or so, and am just getting back up to speed. I went over and measured today. Looking at a plan view, the two chassis rectangular rails on the upper portion of the chassis running fore aft are 37" wide between. There is also a diagonal tube leading from the bottom side of those,forward to the lower chassis rails. Those are about 42" in between. Looking from the back, its about 24" from the top rectangular cross rail to the lower rectangular cross rail. Also in rear view the two uprights rails that connect those cross rails are 30.5" apart at the top and about 17" apart at the bottom. Hope this helps. Its a tight fit for the alfa v6.

  6. #26
    Free user
    Join Date
    Feb 2017
    Location
    Michigan
    Posts
    40
    Rep Power
    0

    Re: New Michigan Member

    Thanks. Now I have to go measure my engine. =)

Similar Threads

  1. New member USA
    By mr2by4 in forum Hello I just Joined
    Replies: 19
    Last Post: 13-01-2015, 17:30
  2. New member in USA
    By IamJacksFiero in forum Hello I just Joined
    Replies: 4
    Last Post: 08-12-2014, 08:35
  3. Hi there! New member from UK.
    By MadBeef in forum Hello I just Joined
    Replies: 5
    Last Post: 15-08-2013, 08:23
  4. Another new member
    By Picasso in forum Hello I just Joined
    Replies: 4
    Last Post: 11-05-2012, 11:31
  5. New member!!
    By Deltona_evo1 in forum Hello I just Joined
    Replies: 0
    Last Post: 10-11-2011, 19:40

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •