- Last Supersite Thread - Alfa V6 Engine & Box Weight
- Engine question
- The KISS thread
- recommendations on engine work while out of car
- Fuel system design
- Body Panel Supports
- Beta based hub P.C.D. sizes
- A/C installation?
- Wheel Studs
- Fixing headlamps
- Rear bulkheads.
- Fitting Windscreens
- X1/9 steering column
- The Sheet metalwork thread.
- Quad light pack
- Best primer for the chassis?
- Fixing rear spoiler to rear clamshell
- JIC fittings and torque
- Head Lining
- fuel pump for 24V Alfa engine
- Tires
- Radiator grille
- Hawk fuel tanks
- inner door handles
- Clutch pedal not returning quickly enough.
- Gear knob
- Front Clam Pivot Point - Moved for Lower Lamp Pod
- Registration
- Plumbed in fire extinguisher
- Wiper linkage
- Wiper Motor Arm and Wheelbox
- minilite wheels
- LSD Pistonheads Q&A
- Gearbox split
- Corse wiper
- "fuelfiller gasket"
- Heater controls and IVA
- Coffin Spokes and centres
- Fitting throttle bodies to the Alfa V6
- Steering rack mod
- GRP4 Throttle Pedal
- MR2 gear lever
- GRP4 Dash Decals
- Tyre pressures
- michelin tb 15 vs pirelli p7
- MSA noise test
- ground clearance
- roll bar padding
- Some good info on CV preparation
- door hardware
- Help please - What is this?
- Wheel alignment!
- Corse heating air duct flanges
- trunk lid fitment
- fuel vapor recovery and charcoal cannister
- Placement of lenses,mirrors, etc
- Seal Part Number
- Dynamat - Has anybody used this before ?
- Mudflaps
- Fuel lines
- Sreen washer or washer wipers
- attaching tow-ring/hooks
- Fuel filler hose
- Gearbox Oil
- Steering column/ ignition lock conundrum
- Steering Wheel Size
- fuel vent valve
- Does anyone recognise this engine mount?
- door handle rods and rubber bases for the clamshell latches
- Some real nice TIG work!
- Hawk Measurement
- Steering rack
- Bolt torque
- Engine Cleaning
- Chassis 'rust proofing' and foam?
- Windscreen dimension
- exhaust too loud!
- Corse steering rack slack
- Tyre pressures
- Another fuel hose failure
- Exhaust systems
- To powder coat, or not to powder coat?
- Stratos Catalogue / Manual
- Flywheel
- Steering Column Bush Replacement X1/9
- 6 point harness
- Lancia delta Integrale cv joint info
- Well, the usual 2 steps forward and 1 step back
- New rollcage regulations
- Fuel smell from tank
- Coating the underside of the panels
- Mobile Scissor Lift
- What road tyres do you use?
- Gripper LSD working?
- Powder coat v paint
- Tyres for Hawk 8" rim Coffin Spoke wheels
- Heat Shield - What options given Zircoflex supply problems please?
- X1/9 Shrouds
- fuel tank venting
- Dino/Stratos window up/down slider knob
- Fire extinguisher system
- spotlight pod lamps
- Captive nuts
- Hawk Measurement ?
- Garage ceiling height
- Tyre options
- Rear view mirror position
- 15 & 17 “ wheel dimensions & engine revs for sequential box.
- Plastic parts cleaning
- Help with DBW issues with Motec ECU
- Fuel tank venting - DIY carbon canister?
- Dynamat Superlite
- Will an all flexible hose brake system pass IVA ?
- Thread locking
- Front undertray
- door handle question
- 1300 vs 1500 Fiat X1/9 upper steering column
- Document upload to forum
- Alfa 5 x 98 x 6" wheel to fit Hawk?
- Hawk Measurement (again)
- Making metal parts
- Seat edge getting damaged
- immobiliser
- Hawk wheels on Corse - can it work?
- In tank fuel pumps and plumbing.
- Spare tyre/wheel options to carry when travelling far away