View Full Version : Front badge
][\/][ajor
09-09-2012, 17:06
Just bought this and hoping it makes a good bonnet badge
3121
][\/][ajor
12-09-2012, 22:14
Drilled the rivets out from the rear....
3132
And after 10mins with Cilit Bang
3131
Not bad. Not perfect but with a little more effort it won't be too bad. I'll call the marks Patina!
Guy Mayers
12-09-2012, 22:58
Here's a seller in Italy with four new ones for €120 plus shipping if the badge doesn't come up to expectations! Just need to get a consortium together otherwise you're speculating!
http://www.ebay.it/itm/4-COPPE-RUOTA-LANCIA-FULVIA-BERLINA-E-COUPE-II-SERIE-/190579216281?pt=Ricambi_automobili&hash=item2c5f680f99#ht_968wt_986
Guy
][\/][ajor
13-09-2012, 11:41
I wish I'd seen them first....I know, I should've asked :(
Yea, I purchasd a set of those, gave one to Paul.
I managed to find one locally, an old Fulvia saloon hub cap for $5 that had never been on a car. Can't believe my luck.
][\/][ajor
13-09-2012, 17:32
What depth should these be? The outer circle is probably the best place for a reference. One on a previous thread seems thinner than what I have at the minute. (see pic attached) 3136
Guy Mayers
13-09-2012, 17:37
The outer ring should be the same depth as the flag centre section so that it all sits flush on the bodywork. There are other similar Lancia grill badges out there made of decent metal (Flavia I think) but the outer ring is twice the depth so there'd be a gap under the centre of the badge.
Best bet is the Fulvia Sedan hubcap which seem to still be available new in Italy.
Guy
][\/][ajor
13-09-2012, 17:39
Thanks Guy
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.