getting ready to fit body to chassis......should i install any interior trim first?

[bosmass]

As it says, I am hoping to install the body next week on my lister bell. It looks like once it is done, the rollbars along the side of the windshield and around the perimeter of the roof will be very close to the bodywork. So much so, I do not know if I will be able to squeeze the headliner and toolbar padding in between after I put things together. Is it typical to wait to do this until later or do it now while things are apart?

[The Slug]

It is a snug fit... you can get the headlining past but I have had to trim my roll cage padding as on mine you cannot get it all the way round the cage.

[bosmass]

thanks for that, upward and onward...