View Full Version : Beta Volumex drive belt
We need a Beta Volumex supercharger drive belt.
Any idea where we can get one?
:confused:
Struan
turbonutter
09-05-2015, 10:57
Assuming you have one to measure, just search online for the type of belt you need - shouldn't be to difficult....
I no longer have my copy but I seem to remember that there was a spec for the belt in the tech section of Guy Crofts book on the Twin Cam. Perhaps someone else has a copy?
Assuming you have one to measure, just search online for the type of belt you need - shouldn't be to difficult....
Local suppliers cannot match up the tooth spacing/length or part number.....
Guy Mayers
09-05-2015, 11:21
It won't be a standard Volumex belt as that has to drive the power steering pump too. All you can do is measure the old one or the belt run route?
Used to get mine from Fenner belts all those years ago, I may even have an old copy invoice somewhere but I'll have to dig it out for spec plus I used the old power steering pump drive cog, machined out and fixed over the crankshaft pulley to speed up the supercharger 15% or so which might mean my belt spec is too long?
Guy
Thank you Guy, that is helpful...
Struan
Guy Mayers
09-05-2015, 11:49
Just had nostalgia trip through the file of invoices to see if I could find it but there's nothing there. I think I must have given it to Dave Watson when he bought the old engine off me for reference.
http://www.fptgroup.com/Synchronous-Belts/fenner.asp?title=Classical-Timing-Belt&pageid=2652
I'm sure that these guys will be able to help if you can give them the tooth size and belt length.
Guy
Guy Croft's web site refers to a long belt for PAS no teeth number given and two short belts 93t and 99t for £27.00.
David
I got all mine from a local Gear and Bearing supplier Struan. They just ordered in from a catalogue. I think 93 teeth rings a distant bell but does depend on the ratios and tensioner set up you have chosen for the length
Rob
Here you go Stru..... The are still going but they just abbreviated their name to PTE
http://www.pte-ltd.co.uk/belt_drives/belts.htm
http://www.pte-ltd.co.uk/pdf/timing_belts.pdf
marcoos_1
10-05-2015, 11:46
8273This is the belt that I use...I can get it no problem through local factor...it's Gates one. Length etc depends on what idler/tensioner set up you have. Hope this helps...
Thanks everyone, that should be enough to go on. :)
Struan
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.