PDA

View Full Version : Laser Cutting



Stableblock
11-06-2018, 09:18
Hello
Has anyone used a laser cutting service for Alloy? (I'm thinking dash panel from pre anodised sheet). If so would you share supplier and experience please?

Thanks

Peter

LPH_UK
11-06-2018, 10:15
Use a local place all the time and never had an issue. For thin gauge stiff like dash panels you get a really well defined cut/edge.

Bit far from you though!

colleyv12
11-06-2018, 11:25
I just used a water jetting company in Glasgow, half the price of laser cutting for the same panel, back of cut outs where a bit rougher and needed tidying, but front was acceptable