Laser Cutting

[Stableblock]

Hello
Has anyone used a laser cutting service for Alloy? (I'm thinking dash panel from pre anodised sheet). If so would you share supplier and experience please?

Thanks

Peter

[LPH_UK]

Use a local place all the time and never had an issue. For thin gauge stiff like dash panels you get a really well defined cut/edge.

Bit far from you though!

[colleyv12]

I just used a water jetting company in Glasgow, half the price of laser cutting for the same panel, back of cut outs where a bit rougher and needed tidying, but front was acceptable