Front Upper Control Arm Bushings / 82294151

[GriotsMotors]

Hello, I'm looking for 4 x 82294151 Front Upper Control Arm Bushings and have been unable to source these.

I was able to find lower bushings, but no luck on the uppers.

Vehicle is a 1974 Lancia Stratos.

Thank in advance, any insight is greatly appreciated!

-Brad

[ProtoTipo]

Hawk cars have remanufactured the OE Stratos Stradale suspension components.
Guy Mayers on this forum may be able to advise.

[GriotsMotors]

Hawk cars have remanufactured the OE Stratos Stradale suspension components.
Guy Mayers on this forum may be able to advise.


Thanks for the reply, I have attempted to send a message via the website and it doesn't go through.
I also attempted to send an email to info@hawkcars.net and it gets authorization error.
Can you send me his information on the forum so I can send a PM?

Thank you,

[ProtoTipo]

Thanks for the reply, I have attempted to send a message via the website and it doesn't go through.
I also attempted to send an email to info@hawkcars.net and it gets authorization error.
Can you send me his information on the forum so I can send a PM?

Thank you,

I'll ask Gerry for you and report back.

[ProtoTipo]

'Not heard anything back yet, but is it this bush? (from dinoparts.de):
The Hawk part uses a Hawk nylatron bush, so is probably not interchangable, or at least not the same. That's just a guess though.

[ProtoTipo]

Gerry says this:
"I think they might be tricky, I have fitted different top wishbone 'poly' bushes"

They look so much like Lancia Beta suspension bushes, but the part number is different.
Knowing the OD,ID and length would be good?

[GriotsMotors]

Correct from dinoparts.de, emailed prior to posting and they are unavailable. Also unavailable from gruppo ricambi bielstein.

OD: 29.50mm
ID: 12.00mm
Length: 33.00mm
Flange OD: 40.00mm

May have to resort to something aftermarket unfortunately.

[john]

If you know someone handy with a 3d printer, they can make you a mould and cast some bushes in a hard polyurethane.