View Full Version : Wanted: Lancia Stratos Choke/Manual Idle Lever
GriotsMotors
16-01-2024, 19:45
Hello,
We are looking for the plastic covers/trim for our choke and manual idle levers.
It is listed as PN# 4309616 (15 in the provided diagram)
Is there a cross reference to a fiat? The handbrake assembly appears to be that from an X19, however the choke lever appears to be a different design.
Thanks in advance,
Griot's Motors
22342
Guy Mayers
16-01-2024, 20:13
The handbrake lever on a Stratos is the same as an early Fiat X1/9 1300 with the addition of a s second lever (I think some X1/9's had two though). Protoypo on here will confirm. The plastic knobs are the same on both the X1/9 and the Stratos and notoriously difficult to find. Hawk Cars in the UK may be 3D printing them? I'll see if I can find out for you.
Guy
ProtoTipo
16-01-2024, 20:23
Hawk Cars in the UK may be 3D printing them? I'll see if I can find out for you.
Guy
Yes Guy, Gerry has had new side lever knobs made. I've seen them.
ProtoTipo
17-01-2024, 07:52
Hello,We are looking for the plastic covers/trim for our choke and manual idle levers.
Griot's Motors
Is it just one pair of side lever knobs you need?
GriotsMotors
22-01-2024, 19:01
Is it just one pair of side lever knobs you need?
Correct, just the one pair.
ProtoTipo
23-01-2024, 07:20
Correct, just the one pair.
Right,.... where on earth did I put them?
ProtoTipo
23-01-2024, 12:49
Right,.... where on earth did I put them?
I've found them! 'Only took me 3 hours.
Send me a PM on here.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.