Wanted: Lancia Stratos Choke/Manual Idle Lever

[GriotsMotors]

Hello,

We are looking for the plastic covers/trim for our choke and manual idle levers.

It is listed as PN# 4309616 (15 in the provided diagram)

Is there a cross reference to a fiat? The handbrake assembly appears to be that from an X19, however the choke lever appears to be a different design.

Thanks in advance,

Griot's Motors


22342

[Guy Mayers]

The handbrake lever on a Stratos is the same as an early Fiat X1/9 1300 with the addition of a s second lever (I think some X1/9's had two though). Protoypo on here will confirm. The plastic knobs are the same on both the X1/9 and the Stratos and notoriously difficult to find. Hawk Cars in the UK may be 3D printing them? I'll see if I can find out for you.
Guy

[ProtoTipo]

Hawk Cars in the UK may be 3D printing them? I'll see if I can find out for you.
Guy

Yes Guy, Gerry has had new side lever knobs made. I've seen them.

[ProtoTipo]

Hello,We are looking for the plastic covers/trim for our choke and manual idle levers.
Griot's Motors

Is it just one pair of side lever knobs you need?

[GriotsMotors]

Is it just one pair of side lever knobs you need?

Correct, just the one pair.

[ProtoTipo]

Correct, just the one pair.

Right,.... where on earth did I put them?

[ProtoTipo]

Right,.... where on earth did I put them?

I've found them! 'Only took me 3 hours.
Send me a PM on here.