Hawk alloy instrument panel: brand-new, unused & uncut

[Two-Eight-Six]

After announcing new, Hawk-supplied instrument panel for my latest project - refurbishing the pod & instruments on my own car - now I don't need it.

Assumption I'd replace this panel turned out pessimistic, since my old one scrubbed-up better than expected, so decided to stick with it. Keep things simple. Which leaves me a new one to sell...

These items fully-reversible and my photo shows the reverse - as it would be for a LHD version. (And also upside down...) You simply turn it around onto the other side to create a RHD dash.

The RHD side has black protective film on it to protect the brushed aluminium finish during installation.

Precision laser-cut instrument-holes = 100 mm in diameter for two main gauges & 50 mm for 5 lesser ones. Plus 4 rectangular openings for switchgear; then 5 small holes pre-drilled to take the standard Stratos fascia-retaining screws. All in their correct locations.

As a rectangular alloy sheet, you simply trim round the edge to match your own car's pod or binnacle - I guess they all vary. Paid 99.60 pounds a few weeks ago for it (@68 pounds plus 15 pounds for carriage; plus 20% VAT on both) - but am willing to resell within club for 85.00 pounds all-in. (Sorry - UK only, obvs.)

[hollytree]

Clive
Thanks for posting. Is the panel the same finish when turned over, as I will have to "flip" it for my RHD Corse in order to get the 5 minor dials above the steering column.
Ta
Steve

[Two-Eight-Six]

Yes, Steve, it is indeed. (As previously mentioned).

That other side (the side you'd use uppermost for a RHD dash) is currently faced with black vinyl to protect the aluminium fascia from scratching or damage during the trimming/installation process.

Once it's in, you peel the black vinyl off to reveal the alloy fascia beneath. Job done

[hollytree]

PM sent. I took my dash out and tried to peel the fake carbon off only to find white plastic underneath.
I will take it if it is still for sale please.
Regards
Steve

[Strat Fan]

PM sent. I took my dash out and tried to peel the fake carbon off only to find white plastic underneath.
I will take it if it is still for sale please.
Regards
Steve
Are you sure it will fit in the Corse Steve?
Your dash panel has a lot of curve along the top edge where the Hawk one is straight.
If there is no material there to trim back it might not fit.

[hollytree]

SH>>>T good point.
Do you have an aluminium dash panel for sale plz?

[Davew1357]

Hi is the panel still for sale?
Regards
Dave

[Two-Eight-Six]

Hi is the panel still for sale?
Regards
Dave

Yes, Dave, following the latest set of messages above, it would appear that my brand-new & unused/uncut Hawk-supplied dash' panel for a replica Strato's is still for sale, after all...

But as my first post (above) also stated, I'm afraid it's got to be a case of "Sorry - UK only, obvs."

[hollytree]

Hi. Sorry about messing you around..
It seems it wont fit my Corse as I had hoped.
Regards
Steve

[Two-Eight-Six]

This item now sold.