Trunk Latch Locking Plate

[VeloceWhippet]

I've got one of these Glove Box Lock Assemblies that originally was for the Lancia Beta. I was planning on using it for the Trunk Lock on my Hawk.
Unfortunately, it didn't come with the Locking Plate that's needed to hold it in place.

Here's a picture of what I have:
https://www.stratosec.com/Forum/blob:https://www.stratosec.com/6dfee672-ed8d-47c0-b45c-f153c625c8e124125

And here's a picture of an original Stratos with it's Lock Assy with the Locking Plate:
24126

I've sent an inquiry to Midwest-Bayless, but no reply yet.

Does anyone know where a Locking Plate can be acquired?

Thanks, Jeff
https://www.stratosec.com/Forum/blob:https://www.stratosec.com/bd8f04ff-4ca1-42c6-88a9-40794b1544c2

[hollytree]

Make one with a bit of metal and a Dremel?
Slide it into position and put a blob of adhesive between the plate and the boot lid to hold the plate it in place

[ProtoTipo]

What's the measurement across the slots Jeff?

OE boot locks are 19mm (there's a good chance to find a clip for those, either OE Fiat part or Vespa tool box lock clip. I'm guessing these might be slightly too small, but not by much?)
1300 Fiat X1/9 glove box locks are 26mm (I have one of those spare)

Chris

[VeloceWhippet]

Make one with a bit of metal and a Dremel?
Slide it into position and put a blob of adhesive between the plate and the boot lid to hold the plate it in place

I figured that if I can't find an original, that's what I'd be doing.

I know I'm going to need to fabricate the piece it interfaces with
2412724128


What's the measurement across the slots Jeff?

OE boot locks are 19mm (there's a good chance to find a clip for those, either OE Fiat part or Vespa tool box lock clip. I'm guessing these might be slightly too small, but not by much?)
1300 Fiat X1/9 glove box locks are 26mm (I have one of those spare)

Chris

The slot is 0.042 inches wide and is 1.040 inches across the barrel of the Assembly. 26mm should work.

Thanks, Jeff

[VeloceWhippet]

Dang, those pictures came across large!

[hollytree]

Can you unscrew the latch on the end of the barrel and cut a thread onto the outside of the barrel for a big nut? May have to ask someone with some decent machines

[Kenny m]

Think this is the one I got for the original lock I got from Chris , I got it from Vespa Jets on ebay but ghe listing is gone now. Link to their website.
https://www.vespajets.com/product/vespa-securing-plate-glove-box-lock-smallframe-px-rally-lml/

[ProtoTipo]

Think this is the one I got for the original lock I got from Chris , I got it from Vespa Jets on ebay but ghe listing is gone now. Link to their website.
https://www.vespajets.com/product/vespa-securing-plate-glove-box-lock-smallframe-px-rally-lml/

Ok for the OE lock Kenny, but not for Jeff's.

I've actually got two of those X1/9 1300 lock clips Jeff. I used to cannibalise them to convert the otherwise non locking OE type.

[Kenny m]

Thanks Chris, I wasn't sure just knew that was what I got for the lock from you at the time.