View RSS Feed

Recent Blogs Posts

All Corse Builds

  1. New Turbo.......

    Name:  IMG_0498.jpg
Views: 1480
Size:  86.7 KB
    Name:  IMG_0499.jpg
Views: 1490
Size:  88.5 KB
    Name:  IMG_0500.jpg
Views: 1587
Size:  92.2 KB

    Not the best welding, but it will work well enough to run the engine without the turbo, fo rthe first mapping session
    Categories
    Corse Build , Engines
  2. Wiring Harness

    Wiring Harness for the engine is now complete & should be with me This week, then I can get on with the chassis connections....
    Name:  ecu.jpg
Views: 1349
Size:  52.8 KB
    Name:  harness.jpg
Views: 1394
Size:  67.7 KB
    Name:  viber image.jpg
Views: 1238
Size:  58.1 KB
    Name:  wiring.jpg
Views: 1271
Size:  64.3 KB
    Categories
    Corse Build , Engines , Electrical
  3. Tidy up Under the front

    One of the changes I made while the car was off the road was to tidy up under the front clam - the main reason for this was to make room to install an Anti Roll bar and to make space for a Water/MEOH tank. The water/MEOH tank & W.I. injection system wont be fitted unless it is the only way to keep the inlet temps down, but at least there is plenty of space for one.

    Changes....
    two DC pumps replaced with one Stewart Components pumps. Battery removed, Anti Roll bar mounted, ...
    Categories
    Corse Build
  4. New gear lever

    Finally I managed to get all of the new gear lever parts together after Anodizing and powder coating.

    Just a couple of Rose joint spacers to male up and its done...

    Name:  GL.jpg
Views: 925
Size:  54.0 KB

    Name:  GL1.jpg
Views: 909
Size:  72.7 KB

    Name:  GL2.jpg
Views: 896
Size:  77.3 KB
    Categories
    Corse Build , Tranmission
  5. Traction Control Wheels

    Some progress with The traction control wheel Installation,

    Front brackets test fitted, they just need tidying up a bit..

    Name:  TC Front left.jpg
Views: 1026
Size:  77.4 KB
    Name:  TC Front right.jpg
Views: 991
Size:  76.9 KB

    The front was nice and simple, but the rears have to use CV joint trigger wheels, these I had to chamfer on the inner bore to fit over the cv joint cover. Next the bracket, but that will need a bit more thought than the front ones.....

    Name:  TC cv joint.jpg
Views: 1029
Size:  61.4 KB ...

    Updated 01-06-2014 at 23:22 by turbonutter

    Categories
    Corse Build
Page 1 of 2 12 LastLast