View RSS Feed

All Blog Entries

  1. Thermostat Housing Installed

    As mentioned at the AGM it was recommended by myself that it would be good if members started using the blogs for the build history - So I will lead by example and now start adding the build record. Any interesting info will remain in the forum threads..................

    All the O-rings arrived from Alfa Workshop so these were installed and lightly greased to allow the installation of the thermostat housing. Discovered also that the thread for the thermostat housing is M7, after ...

    Updated 07-05-2014 at 23:53 by ducatiman

  2. Inside the boxes

    It looks like my photos of the contents didnt upload, so lets try again.

    Name:  US Shopping.jpg
Views: 788
Size:  66.3 KB

    Now to power up the ECU.....
  3. Some Shopping

    Managed to pick up the shopping when we finally got to Houston

    Name:  boxes.jpg
Views: 765
Size:  71.1 KB

    Just need to work out how to carry it all home
  4. New Gear Lever

    I picked up the new support tower for the Gear lever I made this week from Alloy Racing Fabrications, its made from 3mm alloy so should be strong enough!

    Name:  new lever 1.jpg
Views: 992
Size:  115.1 KB
    Name:  new lever 2.jpg
Views: 912
Size:  91.6 KB
    Name:  New Lever.jpg
Views: 949
Size:  102.5 KB

    Just need to finish off the linkage at the stick end, the modification at the box end to reverse the throw has been completed.
    Name:  P1070408_resize.JPG
Views: 1010
Size:  131.6 KB
    Name:  P1070410_resize.jpg
Views: 983
Size:  58.1 KB

    Lets hope it ...
  5. Lower Compression Pistons

    Just Ordered new pistons to replace the damaged ones, these have a deeper dish, now 5.2mm deep, to drop the compression ratio to ~8.3:1. Pistons will have coated skirts & Total seal rings.

    Name:  3d view.jpg
Views: 974
Size:  20.0 KB
    Name:  Side View.jpg
Views: 782
Size:  17.8 KB
Page 5 of 8 FirstFirst 12345678 LastLast