View RSS Feed

All Blog Entries

  1. Finally got round to he Engine Build....

    As the tiitle, 11months after the head gasket blew at Blyton, I have finally got round to rebuilding the engine, New pistons fitted with Total seal rings, New gasket set, re used all bearings as they were like new, so no need to change.. Just the cams to install and its ready to go.

    Unfortunately I am back to work at the weekend, so it will have to wait until october for the Mapping.....##
    Name:  P7210034_resize.jpg
Views: 1036
Size:  95.5 KB
    Name:  P7210037_resize.jpg
Views: 976
Size:  80.0 KB
    Name:  P7210039_resize.jpg
Views: 965
Size:  90.6 KB ...
    Categories
    Uncategorized
  2. Coolers & Pipework Installation

    Started on the installation of the cooling system. The original design has been changed after several good emails with other members of the forum. I originally had one electric pump in the return line to the radator and one in the feed to the engine, mainly as this gave a nice clean installation. This has now changed so that both the pumps will be in the feed line to the engine, the main reason for the change is ensuring that the operation of the expansion tank feeding into the suction side of the ...
    Categories
    Uncategorized
  3. Fly By Wire Throttle

    Just installed the new throttle pedal for Fly by Wire with my New ECU.

    Nice Pedal from Lister Bell - Throttle Pedal Pot is Vauxhall.

    Name:  pedal bracket.jpg
Views: 1027
Size:  86.2 KB

    Name:  pedal.jpg
Views: 973
Size:  66.8 KB
    Categories
    Uncategorized
  4. New gear lever

    Finally I managed to get all of the new gear lever parts together after Anodizing and powder coating.

    Just a couple of Rose joint spacers to male up and its done...

    Name:  GL.jpg
Views: 887
Size:  54.0 KB

    Name:  GL1.jpg
Views: 872
Size:  72.7 KB

    Name:  GL2.jpg
Views: 859
Size:  77.3 KB
    Categories
    Corse Build , Tranmission
  5. Traction Control Wheels

    Some progress with The traction control wheel Installation,

    Front brackets test fitted, they just need tidying up a bit..

    Name:  TC Front left.jpg
Views: 994
Size:  77.4 KB
    Name:  TC Front right.jpg
Views: 960
Size:  76.9 KB

    The front was nice and simple, but the rears have to use CV joint trigger wheels, these I had to chamfer on the inner bore to fit over the cv joint cover. Next the bracket, but that will need a bit more thought than the front ones.....

    Name:  TC cv joint.jpg
Views: 996
Size:  61.4 KB ...

    Updated 01-06-2014 at 22:22 by turbonutter

    Categories
    Corse Build
Page 3 of 8 FirstFirst 12345678 LastLast