View RSS Feed

All Blog Entries

  1. New Gear Lever

    I picked up the new support tower for the Gear lever I made this week from Alloy Racing Fabrications, its made from 3mm alloy so should be strong enough!

    Name:  new lever 1.jpg
Views: 1482
Size:  115.1 KB
    Name:  new lever 2.jpg
Views: 1398
Size:  91.6 KB
    Name:  New Lever.jpg
Views: 1434
Size:  102.5 KB

    Just need to finish off the linkage at the stick end, the modification at the box end to reverse the throw has been completed.
    Name:  P1070408_resize.JPG
Views: 1475
Size:  131.6 KB
    Name:  P1070410_resize.jpg
Views: 1442
Size:  58.1 KB

    Lets hope it ...
    Categories
    Uncategorized
  2. Lower Compression Pistons

    Just Ordered new pistons to replace the damaged ones, these have a deeper dish, now 5.2mm deep, to drop the compression ratio to ~8.3:1. Pistons will have coated skirts & Total seal rings.

    Name:  3d view.jpg
Views: 1442
Size:  20.0 KB
    Name:  Side View.jpg
Views: 1238
Size:  17.8 KB
    Categories
    Uncategorized
  3. New Fuel Tank

    New Fuel Tank Designed, Has 10+ litres extra capacity, so might stop me running out...

    Some addons to check for space..
    Name:  fuel tank mods2.jpg
Views: 1528
Size:  134.9 KB

    From which the design evolved to make the tank.

    This is a half scale model in paper.

    Name:  tank 1.jpg
Views: 1468
Size:  48.5 KBName:  tank 2.jpg
Views: 1427
Size:  53.1 KB

    Full size tank will be alloy and foam filled.

    The new tank will be deeper, so does anyone know if the VDO dip tube senders can ...
    Categories
    Uncategorized
  4. New Parts - New Battery

    Picked up a new battery at Autosport, on Odyssey PC950, this will mount inside the crossmember in the cabin on the passsenger side - freeing up space for other things in the front of the car. Also fitting a "normal" isolator switch as my fancy electrical one has failed....

    Name:  odyssey PC950.jpg
Views: 1261
Size:  91.3 KB

    Name:  odyssey.jpg
Views: 1248
Size:  82.9 KB

    Just waiting for a nice mounting bracket to be made up to hold it secuerly in place.

    Also picked up some custom ...

    Updated 13-01-2014 at 22:18 by turbonutter (add photo)

    Categories
    Uncategorized
  5. Mechanical water pump

    As I said before (I think) I will be using a mechanical pump again, so I have the new GTA pump, complete with metal impeller, thought I would check that it fits to be sure it is the right pump, It fits ok, but when fitting the pulley , it dosent line up with the crank pulley.......

    Name:  gta pulley 1.jpg
Views: 1547
Size:  50.1 KB

    Of course this is due to me using a 164 24V crank pulley, as this has the crank trigger wheel, I did think of ordering a 164 pump, but that probably woyldnt fit to ...
    Categories
    Corse Build , Engines
Page 5 of 8 FirstFirst 12345678 LastLast