V6 3.0 12v inlet runner gaskets

Hi All,

Anyone got 6 inlet runner gaskets for a AR 164 3.0 12v engine please?

Complete gasket set I bought said it was compatible but for some reason the inlet runner gaskets are incorrect.

Cheers,
Chris

do you have a photo or diagram?

Inlet to Head
https://www.ebay.co.uk/itm/133297594474
Inlet to Runner (I think)
https://www.ebay.co.uk/itm/Genuine-A...-/253453735808
Or maybe
https://www.totallyalfa.com/shop/eng...itre-60513868/

I'm only finding the 60513868 part number on 24v listings on the web so these may be wrong. If anyone has an inlet runner for a 24v runner and can measure the ID of the gasket and stud hole centre to centre I can compare it to a 12v runner to see if it's compatible?

Or just buy some high temperature gasket material and cut to suit?

Guy

Many thanks Guy, the TotallyAlfa ones look correct, but will check with them first regarding size. Not sure why I didn't see those on my original search!

If no good, then as you say can make my own :)

Thanks again,
Chris

I might have some as I bought a complete engine gasket set and have fitted ITBs so not used the inlet runners. Will have a look in the garage tomorrow.

Edit - just realised you want 12v. Mine are 24v are they the same?

If you measure the internal diameter of the gasket and the hole centre distance too Chris can compare that to the runner base.
Guy

Hi chaps,

Ok runner ID is 38mm and hole centre distance is 60mm.

Many thanks,
Chris

That's what I've got for my 12v gaskets, they're symmetrical across the centrelines. ie will fit either way up.
Thanks for measuring!
Guy

Not been into the garage today, will have a look tomorrow.