Ferrari Dino engine & gearbox

For anyone who would like to build a Tin car like Gerry’s one!
No connexion with the seller!

https://rmsothebys.com/en/auctions/p...arbox/1339943/

I reckon it will go for more than the estimated ?10-20k.

Quote:

---

Originally Posted by Stratos Fear

I reckon it will go for more than the estimated ?10-20k.

---

I doubt it Peter.
A good engine and box is about ?35k tops, and can you see a crankshaft, connecting rods and pistons in the photos?
There's got to be a good reason why it's in pieces, too.

And 20% buyer's premium too....that's an expensive pile of bits!

My best guess would be London, but the storage facility is not disclosed.

Then + 10-25K to rebuild it
One I rebuilt 3 yrs ago. from a pile of scattered parts, not all in same series, so bit of a mix match, as there 3 series on 2.4 + the earlier all alloy 2.0
A new distributor cost 3k from Ferrari

Attachment 20741

Quote:

---

Originally Posted by sean999r

Then + 10-25K to rebuild it
One I rebuilt 3 yrs ago. from a pile of scattered parts, not all in same series, so bit of a mix match, as there 3 series on 2.4 + the earlier all alloy 2.0
A new distributor cost 3k from Ferrari

Attachment 20741

---

Great job! It Looks very nice!
Last time I have seen one like yours for sale it’s was around 40k!!

Quote:

---

Originally Posted by sean999r

Then + 10-25K to rebuild it

---

Exactly.....

The majority of the value in this lot, is the transmission. The engine, less so.

'Just had a closer inspection of these Dino parts:
There is only one Lancia Stratos in the world with an outer bell housing like the one in this collection.
The cast iron block for sale is a Fiat Dino block, not a Ferrari Dino block. They are almost identical, but the Fiat block has four threaded holes where the Ferrari block has clearance holes.