Blyton track day

[turbonutter]

Hi Bob,

Glad someone is thinking - when it went, I just gave up I think, like you say someone has a voodoo doll and loads of pins!!!!!

I hadnt thought about epoxy metal, Any particular favourite brand?

as its just a pin hole, i guess it would be prudent to enlarge the hole a bit so the epoxy goes in and helps it grip, or will it just stick on the top if i rough it up??

Anyway thanks for the Idea, I might make it yet - Still need to go to AET though to see if they can sort the Engine propperly, but I guess the epoxy will dry in an hour or so, so time to do it tomorrow!

Cheers

[Cadami]

I used a generic epoxy putty on my swirl pot ali welded jic fitting...the weld was leaking!! Worked a treat but now replaced. I just wrapped it around the affected area....sticks like poo....

[turbonutter]

I used a generic epoxy putty on my swirl pot ali welded jic fitting...the weld was leaking!! Worked a treat but now replaced. I just wrapped it around the affected area....sticks like poo....

Cheers

First stop tomorrow - auto spare shop
then off to get the engine sorted - Hopefully blyton will be on again!

[Monte76]

Where there's a will there's a way, don't give up just yet guys, we're all looking forward to seeing your cars in action at Blyton, keeping our fingers crossed for a full turn out.

vince.