Patriq,you can drill off the 'burred' over end with a 6mm drill,gently drill till you see the outline of the hole that is in the black handle part.Old used ones tend to be a bit seized your NOS ones may be free to rotate,grip the head with mole grips.
I bought some 5mm stainless clevis pins.
Cut them about 2mm longer than the width of the catch part then with a small centre drill (No2)in the lathe drilled a centre hole to almost 5mm diameter.
When I assemble them up I can peen over with a 8mm ball bearing.
https://www.boneham.co.uk/clevis-pin...clevis-pins%2f
Reply With Quote
Bookmarks