Torque specified is dry as Graham says....

My tilton clutch is 22lb/ft or 29Nm, so slightly more, but still less than your quoted figures...

From tilton Manual....
D. Clutch Assembly Installation
Now that the clutch is assembled with discs, install it onto the engine as follows:
1. Slide clutch over the mounting bolts and make sure the heads of the bolts are secure
against flywheel lip. Start aircraft-type washers and nuts onto each bolt by hand.
2. Align discs with an alignment tool or a spare input shaft.
3. Tighten the six bolts in a criss-cross pattern, half-of-a-turn at a time until bottomed. Torque
the nuts to 22 lb-ft (lower when using oil or Loctite).

25Nm should be fine - Or a bit more if you like. The main thing is they are all tightened the same..