At the moment no ; as am trying to source eventual drawings or part to be borrow and then redraw all stuff in 3D
Otherwise there is a company there selling Titanium who did a set of titanium hubs and cv joint splined carrier and the set was more close to 11 000 /12000 euros !!!!!!!! Crazy !
I asked ( as I know their boss ) if it was possible to get drawings !!!!am still waiting the reply
Years ago I did apost on this subject :there was this link
http://www.titane-services.eu/epages...lancia-stratos
There is one important point to know about Marvic refabrication parts ; they are strictly machined as they where on 70's including the very special steel insert that hold the bearing ( hard to find!).
They deliver with the upright if I remind the special big round screw that pusches onto this bearing ( so alot of tricky machining !!)
Watching at the titaium parts to my modest opinion one steel hubb would cost not below 750/800 euros and quite same for the splined shaft supporting the CV joint
Again this is due to low batches possible for sure and splines to achieve ( now machine shops are very few specialised on such machining!)
Reply With Quote
Bookmarks