New Group 4 rear Uprights

[strat24v]

Fully understand the costs. Selling half a dozen a year isn't going to make him rich.

[jeffdavison]

Is the cost for a single or for a pair?

JD

[pim]

Costs for one piece: "menge": 1

[strat24v]

Roberto had them for maybe 1500 euros each iirc??

[LM mic]

If some members will be interested Marvic is ok to do avery small batch ( mini 2 or 3 pairs) for something like 1000euros each (plus Vat)

Only issue I see is sourcing shock absorbers to match and adapt the top of each brand of chassis ( Allora , Hawk etc !!)

[strat24v]

Any idea of cost for the bearing and hub?

[LM mic]

At the moment no ; as am trying to source eventual drawings or part to be borrow and then redraw all stuff in 3D

Otherwise there is a company there selling Titanium who did a set of titanium hubs and cv joint splined carrier and the set was more close to 11 000 /12000 euros !!!!!!!! Crazy !
I asked ( as I know their boss ) if it was possible to get drawings !!!! am still waiting the reply
Years ago I did apost on this subject :there was this link

http://www.titane-services.eu/epages...lancia-stratos

There is one important point to know about Marvic refabrication parts ; they are strictly machined as they where on 70's including the very special steel insert that hold the bearing ( hard to find!).
They deliver with the upright if I remind the special big round screw that pusches onto this bearing ( so alot of tricky machining !!)

Watching at the titaium parts to my modest opinion one steel hubb would cost not below 750/800 euros and quite same for the splined shaft supporting the CV joint
Again this is due to low batches possible for sure and splines to achieve ( now machine shops are very few specialised on such machining!)