New Group 4 rear Uprights

**strat24v** · 23-05-2016, 00:49

Any idea of cost for the bearing and hub?

**LM mic** · 23-05-2016, 13:32

At the moment no ; as am trying to source eventual drawings or part to be borrow and then redraw all stuff in 3D

Otherwise there is a company there selling Titanium who did a set of titanium hubs and cv joint splined carrier and the set was more close to 11 000 /12000 euros !!!!!!!! Crazy !
I asked ( as I know their boss ) if it was possible to get drawings !!!!

am still waiting the reply

Years ago I did apost on this subject :there was this link

http://www.titane-services.eu/epages...lancia-stratos

There is one important point to know about Marvic refabrication parts ; they are strictly machined as they where on 70's including the very special steel insert that hold the bearing ( hard to find!).
They deliver with the upright if I remind the special big round screw that pusches onto this bearing ( so alot of tricky machining !!)

Watching at the titaium parts to my modest opinion one steel hubb would cost not below 750/800 euros and quite same for the splined shaft supporting the CV joint
Again this is due to low batches possible for sure and splines to achieve ( now machine shops are very few specialised on such machining!)

**strat24v** · 23-05-2016, 15:48

For a Hawk owner and to have the geometry correct, it means heavily modified top mounts and the lower inner wishbone mounts moving in by 50mm each side which involves a fair amount of re -fabrication of the lower cradle.

**LM mic** · 23-05-2016, 16:02

Originally Posted by strat24v

For a Hawk owner and to have the geometry correct, it means heavily modified top mounts and the lower inner wishbone mounts moving in by 50mm each side which involves a fair amount of re -fabrication of the lower cradle.

Yes !!!
And quite same issues with LB kits

This is why I doubt some one could be interested on those !!!
I think this is only interesting if some one wanted to replicate in every details the rear tranny ; this will need to think and ingineer before to do the rear tubes !!!!
So very very very rare person I guess

!!!

Otherwise we know now that the parts are avaible and where ........

Dreaming more ...one day or another someone would redo ( what have been done before !!) "real deal" chassis !!!
But we are no more on the REPLICA world !!!!!

**strat24v** · 23-05-2016, 16:38

I'm in the process of changing my Hawk chassis to pretty much original Stratos geometry but using a new billet upright. It's a fair amount of work and costing an unhealthy amount of money. As the geometry is, it's probably adding a fair bit to snap oversteer, sure a few have found this.