Is this why you need Phil? I'm not sure if it's 12v or 12v Cloverleaf yet though! If it's what you need can you measure the OD on the throttle body and AFM so I can compare it?
Guy
Hi
As you know I have entered Nellie in Tour Britannia in August but it turns out that the convoluted / ribbed pipe between the Airflow meter and the throttle body is badly perished and causing bad pinking !!
Does anyone have a good spare or any other suggestions
Engine is Alfa 3000 12V
Cheers
Phil
Is this why you need Phil? I'm not sure if it's 12v or 12v Cloverleaf yet though! If it's what you need can you measure the OD on the throttle body and AFM so I can compare it?
Guy
Last edited by Guy Mayers; 14-07-2014 at 18:34.
An alternative if the one guy has is wrong, could be a silicone elbow with a couple of bolt in take offs for the small hoses.....
No problem Phil, I can post it on Wednesday easily enough.
Guy
Home in a couple of hours Phil, it's on the dining room table so I'll remember to measure it and let you know. If it's right it'll be on the way to you tomorrow or Thursday.
Guy
I've measured the rubber tube I've got Phil and it looks like it's got a 69mm ID at the AFM and 84mm ID at the Throttle Body. If your guy measured the OD of the rubber pipe then mine will be too big. Hopefully he's measured the OD of the ally that the tube connects to! Either way I'll bung it in the post to you as soon as I can, if it's too big you can try wrapping a bike inner tube around the AFM and Throttle Body until it fits nice and snug?
Cheers
Guy
Bookmarks