Wheels to borrow/rent/buy please for IVA test

**john** · 09-08-2014, 21:22

What has been done before is to add a wheelarch extension out of fibreglass or even silicone as a temporary measure to cover the wheel and tyre projection.
Mould it with cardboard and parcel tape. A day's work and a few quid?
Corse bodywork can end up off centre but you don't have to be a genius to get it right. It just takes a little care.
Being aware of the invoices which were flying around for all the "professional" work done on your car, all I can say is it should have been right before it came to you.
Do the fronts clear those big brakes or did you have to fit spacers?

**Cadami** · 09-08-2014, 23:18

Be careful how temporary it looks!! I borrowed a pair of Alan's rear arch extensions to pass IVA

**hollytree** · 10-08-2014, 13:34

Originally Posted by Cadami

Be careful how temporary it looks!! I borrowed a pair of Alan's rear arch extensions to pass IVA

Sorry. Who is Alan and how do I borrow a pair.
What about fronts?
Did yours pass with these

Regards
Steve

**john** · 10-08-2014, 14:03

It's just from your original post you said the left hand side was worse than the right? To me this would imply that however nicely they were done then they are not quite right?!
I have seen invoices for the bodywork on your car and have been told that it cost that much to have it done right. It now seems that it wasn't quite done right at all!
Anyway, none of that is particularly relevant to your problem. Just interesting to me.
For the fronts you would have to make something similar to what is shown in the photo for the rears.
I have just had to shorten the front wishbones and TCA's on Frederic's Corse S by 15mm to accommodate Craig's wheels. I think the LB bodywork is wider overall than the Corse.

**catswhiskers** · 10-08-2014, 15:10

Or you could just put it through the IVA with a set of standard Alfa wheels & tyres. Might look silly but if they don't stick out they can't fail.

Mick

**john** · 10-08-2014, 15:28

This is exactly the kind of situation where you could go round in circles for weeks tho' when it is best to just grasp the nettle and get over it.
Will anyone else's wheels fit over the brakes and have any better offsets?
Best just to do the work.
There is no off the peg solution in Stratos building.

**john** · 10-08-2014, 15:50

[QUOTE=john;21661
There is no off the peg solution in Stratos building.[/QUOTE]
Actually, I'll just correct myself there. There WAS no off the peg solution. Now you can buy an LB!

**StruanR** · 10-08-2014, 16:36

I have a set of 8x15 annd 10x15 Image wheels and tyres, Alfa centres. Deep in Kentish jungle though..
too big I expect
Struan

**hollytree** · 10-08-2014, 13:33

John
The arches are nicely done, it may just be the wide wheels and tyres I used.
With the help of Craig and Hispec. Track control arms and bells it all works beautifully.
Regards
Steve