Hi all.
Well, I`ve placed my order with Gerry and have started the journey.
I`ve never built a kit before but have played cars all my life and done some fairly extensive projects so am still full of confidence at the moment!
So far I`ve picked bits from a X19, gathered a few lamps ,instruments, switches etc and currently ending the life of a 164. I have trawled the forum but can`t find any advise on best dismantling practice.... As I`m intending to install the engine with the standard ecu (at least to start with!) should I carefully unpick the Alfa loom to isolate the engine management wiring and connect this, or is this a bit optimistic! Maybe start again with a few spools of cable and a wiring diagram. Where`s the easiest to follow wiring diagram?
Thanks in anticipation.
  1. Simon.