The IVA man did not like the black plastic knobs for the windows that came with my Corse kit.
I cant see any sharp edges, but hey!?
They thread size I have in the back of them is M10.
Can anyone tell me what window knobs get through IVA please?
Regards
Steve
Had no issues with the ones Craig supplied, not sure if its M10 mind cant check as i'm at work.
That's a new failure area Steve. Does the edge need a specific radius? Temporary cover / pad it out?
I believe it should have a minimum radius of 2.5mm which is common to all interior fittings that can be contacted by either a 165mm or 100mm sphere dependant on where it is in the car.
If it is a standard M10 thread can you not just buy a couple of round plastic knobs from Eblag and fit them temporarily for the test? it should still be possible to undo and do up, if not easily and then swap them back after.
The ListerBell ones are M8 and although mine, Ian's and several others have passed; technically and if the tester was having a bad day they could have failed due to the lack of a radius on the centre boss. Not sure if Craig has altered them slightly now.
Last edited by STR_Strat; 21-08-2014 at 18:57.
I think you will find that the radius required internally is more than 2.5mm. That;s for external surfaces and projections.
19mm rings a bell for inside?
Interior design features and fittings in the “specified zone” which are contactable with a 165mm sphere must have a radius of curvature of 2.5mm or greater, except where a projection from a panel is less than 3.2mm where the edges must be at least blunted. (see note 3, 4and 9) see annex 1 and 2
The 19mm radius only applies to the bottom edge of the dash panel
Posting Permissions
Reply With Quote
Bookmarks