Brake Pads

[strat24v]

Hi,

My Billet 4 are the same piston size front and rear, but the front master cylinder is a smaller bore than the rear.

Andrew

Martin had said my similar setup would be ok, same calipers and discs front and rear, one size smaller master cylinder on the front.

[NoCorseChris]

Another vote of confidence for Martin's calcs. Eventually(!) followed his advice properly on my car when I had it and the braking was excellent. For a long time I had it with way too much front brake compared to rear. Was a bit of a mish-mash of bits, but it worked great in the end. Can't recall the numbers I used now but it was what Martin told me to use. You certainly do need a good dose of rear brake capacity.

[Bernard]

Another vote of confidence for Martin's calcs. Eventually(!) followed his advice properly on my car when I had it and the braking was excellent. For a long time I had it with way too much front brake compared to rear. Was a bit of a mish-mash of bits, but it worked great in the end. Can't recall the numbers I used now but it was what Martin told me to use. You certainly do need a good dose of rear brake capacity.

Also Chris you have more rubber contact patch on the Rear (Grp4) even with the weight transfer moving to the front