Hi,

Merry Christmas to everyone..... Loads of snow with us, so in the garage !

Has anyone fitted the alternator to the front of a 3.0L 24V Alfa 166 engine.

Standard fitment is to the rear of the engine and this is OK for drive belt routing if there is an Air Con Compressor on the other side.

Part of the issue is the sprung belt tensioner and only so many ways that the drive belt can be reconfigured to use this tensioner.

I'm removing air con and thus no compressor.

I wondered if there was a standard bracket that would be easier than having a wholly new mounting bracket made up.

Andrew