Eric finally fired up today, after many weeks / hours with an electrician and replacing the Gotech ecu with a new DTA unit, rewiring etc, checking all stuff works bit by bit. Fitting a new crank sensor trigger wheel, new cam belt (as the original has been sitting in the same position for about 5 years and during initial start up a few weeks ago it must have slipped two teeth on the rear bank inlet cam) ....
so there's the wiring to tidy up, ecu to fit securely, exhaust to make good with the insertion of 2 Lambda ports, and various other jobs but now the engine is running I will try to get my finger out and get it done !
Reply With Quote
Bookmarks