Beta Volumex drive belt

[Guy Mayers]

Just had nostalgia trip through the file of invoices to see if I could find it but there's nothing there. I think I must have given it to Dave Watson when he bought the old engine off me for reference.

http://www.fptgroup.com/Synchronous-...lt&pageid=2652

I'm sure that these guys will be able to help if you can give them the tooth size and belt length.

Guy

[David J]

Guy Croft's web site refers to a long belt for PAS no teeth number given and two short belts 93t and 99t for £27.00.

David

[Sando]

I got all mine from a local Gear and Bearing supplier Struan. They just ordered in from a catalogue. I think 93 teeth rings a distant bell but does depend on the ratios and tensioner set up you have chosen for the length
Rob

[Sando]

Here you go Stru..... The are still going but they just abbreviated their name to PTE

http://www.pte-ltd.co.uk/belt_drives/belts.htm

http://www.pte-ltd.co.uk/pdf/timing_belts.pdf

[marcoos_1]

This is the belt that I use...I can get it no problem through local factor...it's Gates one. Length etc depends on what idler/tensioner set up you have. Hope this helps...

[StruanR]

Thanks everyone, that should be enough to go on.
Struan