If you think that's bad - just wait 'til you get to teflon fuel lines and fittings!!
Looking good though - can't wait to see the car on the road. In fact, I'll be up in your neck of the woods again in July - my daughter accepted a place at Seattle University, so we need to attend an orientation session and will likely be in the area a lot more often going forward
P.S. Just noticed the brand - so was that price with or without the family discount
Last edited by Paul; 01-06-2015 at 05:51.
I wish that I got a family discount. LOLOriginally Posted by Paul
P.S. Just noticed the brand - so was that price with or without the family discount
Corky
As suggested by Paul, I found a wiper assembly from a Ferrari 348 and will be using it for my wiper system. Still waiting for one missing part, then I need to drill the correct hole pattern in the wiper motor bracket and start figuring out the wiper timing.
Update, got the driver side (USA) door latch mechanism fitted. Test fitted the door window, then realized that I had the Litton/CAE/Napier Sport window, got out the Lister Bell window and test fitted it (see photos) much better fit. I have all the brake lines and clutch line done, missing one fitting (on order). Fuel lines, filters and pump ordered. A lot of little things need tweaking. Hope to hear it run in about a month.
The window photos in the previous post was the Litton window, below is the Lister Bell window.
Well the brakes are done and not leaking. Working on the fuel system, the photo shows the fuel pump in place, the two panels above the pump are where the filters will be installed. Need to re-install the e-brake and route the cable shifter. Also need to finalize the cooling system routing.
Do you have a pump in the tank as well??
Posting Permissions
Reply With Quote
Bookmarks