Craig

Castor is set to 5 degrees at the front.
Camber is 1.1 degree neg front both sides, and 0.5 degree neg. - at the rear having said that after the run the rear nearside in only 0.2 neg (yes I did keep rolling the car back and forth to settle the suspension while adjusting).
So I need to go back and check this. I can also dial out the rear toe in quite easily but I note the original had a Toe out!!!! (of 2mm - which equates to 1.6 degrees toe out per side....)

The "tram-lining" feeling seems more front driven than rear but early days. Would a slightly higher tyre pressure make this worse or better??

The Transformer build manual said ground clearance 130mm but this was for 14 inch (and 205 70 tyres?) so with 15 inch wheel this will be higher, and the original Strato's had a ground clearance of 170mm at the rear of the floor plan. I dont feel it as aero lift problem but will ponder this.

Any pointers as I need to "sign Shades off" so I can get on with some other winter tasks. I hope for a few more test days in coming days to enable this.