Hi
I don't know exactly how the LB works but if you have the chance to get the boot/bonnet release do so ! (you can always sell them on if you decide not to use them)
Phil
Hi,
I'm busy collecting donor parts for a lister bell build.
Do I need the chrome boot/bonnet release too or just the door handles?
cheers
Hi
I don't know exactly how the LB works but if you have the chance to get the boot/bonnet release do so ! (you can always sell them on if you decide not to use them)
Phil
Andy,
I am building a LB. The boot/bonnet release levers operates the Fiat X19 boot/bonnet release catches (2 required) which secure the rear body section to the chassis on the LB. The catches on the Fiat are identical, one is used for the engine cover and the other is used for the boot cover. If you source from one car the engine catch will be more corroded.
Gordon
Same place as an original stratos, in the door reveal, below the keep.
See here (LHD):
http://www.stratosec.com/Forum/album...achmentid=4232
Might I suggest purchasing the super profile book? Loads of pics in there to help with component positioning.
Bookmarks