I have spent the afternoon replacing the clutch master cylinder on my Hyundai Santa Fe.
All done apart from one hydraulic connector that I'm stuck at. Male into female, retained by an h-clip which goes through slots in the female and engages in groove in male. I just can't get the clip in. I presumed insert connector then push clip through, I've also tried putting it in position in the female end and pushing the male end in but that doesn't work. Of course it's right on the bulkhead where you're standing on tiptoe to reach. What am I missing!Help!
Picture is upside down, but you get the drift
(Chair)I added the pic the correct way up ..hope you dont mind?
Reply With Quote
Bookmarks