Have you bought a Hawk too now Clive?
Have you bought a Hawk too now Clive?
Reminds me I must dis/reassemble mine this winter- they've been together a few years. I use a wooden dowel as a drift to knock the rod out from the inside - keeps all the spacers and stuff joined up for reinserting the rod.
I used grease to hold "large washers" in place..... Because I'd bought another couple of rods, I found that inserting one rod from "radiator end" and then another from inside the car to line everything up worked reasonably well.
The final piece of the jigsaw (spacers etc) I found the trickiest to get in... I found that using one of the large washers was the easiest final part to push in and line up.
I have to admit to using a rubber mallet to tap the rod fully through. All seems OK.
I remember using Guy's technique 1st time around and that seemed to work well too.
Good tip ref tightening when it's on the deck... Many thanks.
Andrew
No, John, just an interest in the discussion!
Ahh, well fair enough!Originally Posted by Two-Eight-Six
By the way if you PM me an email address I found a few photos which might interest you!
Last edited by john; 19-12-2016 at 19:29.
Posting Permissions
Reply With Quote
Bookmarks