New Michigan Member

[LM mic]

Sand + Stones ; why not






So possible result ;



Welcome and good luck with your project

[LPH_UK]

Welcome.

If you want something 'different' I can point you to a guy in the UK that does a 500+ hp n/a V6. Based on a 370z block. Bit expensive though!

[MooglyMoog]

Welcome.

If you want something 'different' I can point you to a guy in the UK that does a 500+ hp n/a V6. Based on a 370z block. Bit expensive though!

That actually sounds pretty cool. How expensive?

I was thinking 4G63 turbo. It's the closest semi Chrysler engine I could get with a manual trans. DSM motors. =)

[LPH_UK]

That actually sounds pretty cool. How expensive?

I was thinking 4G63 turbo. It's the closest semi Chrysler engine I could get with a manual trans. DSM motors. =)

Erm - about £15k+ I think. Can check if you are really interested. Should be over there on Wed this week.

[MooglyMoog]

Erm - about £15k+ I think. Can check if you are really interested. Should be over there on Wed this week.

Ha, yeah, that's a bit out of my budget. I am curious how high it revs though.

[LPH_UK]

Ha, yeah, that's a bit out of my budget. I am curious how high it revs though.

I'll ask when I'm there on Wed and report back

[LPH_UK]

Saw him today and asked. He does various versions of the engines from almost stock to 500+HP with fully forged internals.

Standard(ish) engine with original crank and rods, balanced and with lightweight flywheel and their custom ITBs fitted should make 400hp. Said it should rev to at least 8000, probably be OK at 8500. Would cost 10-12k on top of buying the second hand engine to start with as the base for the rebuild.

It's a very compact engine. Much smaller than the Alfa or Toyota lumps. It's only a little bit wider than a Honda K20 4 cyl engine (which is the guys other specialty).

[Ilmor]

Welcome to Michigan. I have a Hawk Chassis that was delivered last October. Very long term project for me but happy to swap Stratos stories anytime. I'm heading down the Frankenstein Ferrari engine route (big capacity / big valve 308QV engine) which I am in the process of building right now. Happy to show you the car anytime.

[MooglyMoog]

Lister Bell owners: Can someone measure the width between the frame members of the rear sub-frame? Also, the height between them? I need rough dimensions for packaging purposes. Im trying to decide if I can fit a Hemi in a Stratos.

Also, Ilmor, Can you measure the height and width of you engine, including the accessory drive?

[MooglyMoog]

Welcome.

If you want something 'different' I can point you to a guy in the UK that does a 500+ hp n/a V6. Based on a 370z block. Bit expensive though!

Do you guys know if anyone has fit a HEMI in these? Would it package?