Photos needed

[The Slug]

Hi Griff, could you mail it to me please at webmaster@stratosec.com please.

If anyone else would like to mail what you have I would be grateful.

Thanks

[Rotor1]

Hi Ian, Griff, I would be interested in seeing the pictures as well, being just at the point where I want to cut some card patterns before cutting the aluminium sheet. My email address is: rotor1@caribsurf.com.

Thanks

Henry

[Griff]

Ian, Henry, sent this afternoon, it's 8.7Mb, so it take a bit of time to download!!

Griff

[pim]

i found these

[Rotor1]

Thanks, Pim, Griff, Frederic and Ian.

Henry

[ProtoTipo]

From the two points I've marked, there is the edge of a 90° bend in the alloy.
This part isn't fastened onto any steel box though, as you can see the rivets carry on up the side of the square box.
The panel is in 'free air' between these points.
Older Transformers (Hawks) don't have this detail.

I remember a green Hawk demo chassis that had the front splash panels glued on (no rivets at all).

[ProtoTipo]

Here's a photo of the older type front Hawk splash.
The later 'covered in' splash panel needs a hole to be able to remove the long Hawk pedal shaft, if the car has those pedals.