Photos needed

**pim** · 21-11-2017, 18:45

i found these

Click image for larger version.

Name: 17 december 2005 013.jpg
Views: 75
Size: 54.3 KB
ID: 12310

Click image for larger version.

Name: 17 december 2005 014.jpg
Views: 73
Size: 69.4 KB
ID: 12311

Click image for larger version.

Name: 17 december 2005 022.jpg
Views: 76
Size: 90.4 KB
ID: 12312

Click image for larger version.

Name: 17 december 2005 020.jpg
Views: 74
Size: 94.9 KB
ID: 12313

**Rotor1** · 22-11-2017, 05:17

Thanks, Pim, Griff, Frederic and Ian.

Henry

**ProtoTipo** · 22-11-2017, 08:24

From the two points I've marked, there is the edge of a 90° bend in the alloy.
This part isn't fastened onto any steel box though, as you can see the rivets carry on up the side of the square box.
The panel is in 'free air' between these points.
Older Transformers (Hawks) don't have this detail.

I remember a green Hawk demo chassis that had the front splash panels glued on (no rivets at all).

**ProtoTipo** · 22-11-2017, 08:36

Here's a photo of the older type front Hawk splash.
The later 'covered in' splash panel needs a hole to be able to remove the long Hawk pedal shaft, if the car has those pedals.

**The Slug** · 22-11-2017, 10:28

Thanks Chris, Thanks Pim

**Rotor1** · 23-11-2017, 13:48

Thanks Chris, there seem now to be many possible ways to construct these splash guards!

And I’m sure there are many other solutions!

Enjoying this build!

Henry

**ProtoTipo** · 23-11-2017, 16:20

Hi Henry,

I made some front splash panels for my Honda engined Transformer.
I must have made a pattern. If I did, I don't know where it is? It would be 2004.