Thanks to both for your much-appreciated & speedy offers/advice, Peter & Guy.
Am sorted now as far as pre-cut fascia plate goes: followed Guy's advice and got a mega-rapid response from Gerry. So plate is ordered & en route from stock, straightaway = an excellent speedy service from Hawk Cars & pleasure to observe Gerry fully back in action, too!
Am aiming to refurbish whole instrument panel housing; to enable its removal for recovering & perhaps also to fit a GPS (or electronic) speedo instead.
My original preference was to transfer everything over to another, spare panel while did so; rather than car be laid up without a flight deck pending improvements. However, these f/g binnacles are, as Guy said, a batch-production item and not in stock; but think can recover my existing housing without the need/expense of obtaining a spare.
So thanks again to all involved for responses, including kind offer of a binnacle from Europe!
Reply With Quote
Bookmarks