Quote Originally Posted by hollytree View Post

I left the circlip on and pushed driveshaft into new diff. Is that right?

I bolted the Quaife to the deeper dished side of the crownwheel - I am now just doubting myself. Is that right?
By driveshaft I assume you mean output shaft?
This is the last thing to go back in once the diff is fitted back into the car. It is comparable to the intermediate shaft on the other side of the diff, it is only in the way until the diff housing is back in the car.
1) fit crown wheel to diff
2) bearings onto diff
3) diff back into housing
4) diff casing on
5) bearing shims positioned
6) output flange seal castings bolted on
7) end float checked
8) bolts torqued
9) output shaft refitted
10) intermediate shaft refitted