Results 1 to 3 of 3

Thread: Laser Cutting

  1. #1
    SEC Member
    Join Date
    Oct 2011
    Location
    Woodbridge, Suffolk
    Posts
    80
    Rep Power
    8

    Laser Cutting

    Hello
    Has anyone used a laser cutting service for Alloy? (I'm thinking dash panel from pre anodised sheet). If so would you share supplier and experience please?

    Thanks

    Peter

  2. #2
    SEC Member
    Join Date
    Jul 2015
    Location
    Leicestershire
    Posts
    1,012
    Rep Power
    14

    Re: Laser Cutting

    Use a local place all the time and never had an issue. For thin gauge stiff like dash panels you get a really well defined cut/edge.

    Bit far from you though!
    Last edited by LPH_UK; 11-06-2018 at 09:19.

  3. #3
    SEC Member
    Join Date
    Mar 2018
    Location
    Scotland
    Posts
    97
    Rep Power
    1

    Re: Laser Cutting

    I just used a water jetting company in Glasgow, half the price of laser cutting for the same panel, back of cut outs where a bit rougher and needed tidying, but front was acceptable

Similar Threads

  1. Tube cutting Templates
    By Stableblock in forum Heating and Cooling
    Replies: 1
    Last Post: 29-03-2018, 09:37
  2. Laser Cutting
    By john in forum General engineering products
    Replies: 0
    Last Post: 22-07-2014, 12:16

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •