I used some nice shiney black 4mm stuff from Demon Tweeks, it's kept its shine for over two years of driving so I'm happy with it.
I'm looking at making some mudflaps and was wondering a) What material ? and b) what thickness?
I've been looking at solid rubber with no re-inforcing - as this shows when you cut it to shape - and was thinking about 4 or 5mm ?
Any views on this?
I used some nice shiney black 4mm stuff from Demon Tweeks, it's kept its shine for over two years of driving so I'm happy with it.
Paul.
Sat in a real one, may never wash again!
MSA spec is 4MM min, there is a company called Kaylan in West Yorkshire they can make pretty much any shape and will mould as well and various colours. Used them on my Sunny when I was rallying, only used one set in 5 yrs apart from ripping one off when reversing!!!
Thanks Steve - I've already got a template so am primarily interested in type of material to use but I'll check out Kaylan anyway.
P
Petty sure it was two pairs of these.
https://www.demon-tweeks.com/nz/gray...dflaps-243651/
And I used an old jar to draw a nice radius to cut the corners.
Last edited by Fingers; 09-05-2020 at 03:12.
Paul.
Sat in a real one, may never wash again!
Realise this is quite an old thread now - just wondered if you had a copy of the template and also what you used to fasten them?
Good info here; Front Mudflaps (stratosec.com)
Good info here; Front Mudflaps (stratosec.com)
Matt, I'll have a look for my template, regards
Griff
Bookmarks