Has anyone got any good suggestions what to use or where to source a suitable solution for the small light which sits above the stop watches on a GP4 dash board.
Image attached for reference
Thanks in advance
"You can lead a horse to water, but a pencil must be lead"
Stan Laurel
Craig,
Mine is homemade with a wiper switch I think as the on off switch
The light is made from a stainless hydraulic bulkhead fitting that's been modified and a small knurled part to act as the shade
Craig,
Mine is homemade with a wiper switch I think as the on off switch
The light is made from a stainless hydraulic bulkhead fitting that's been modified and a small knurled part to act as the shade
I was working on a drawing for a machined option yesterday, it might be the easiest solution.
Last edited by Strat Fan; 01-11-2020 at 11:14.
"You can lead a horse to water, but a pencil must be lead"
Stan Laurel
Bookmarks