Got a wink on

[Jamo12t]

Not sure if this will show the right way up but just for a bit of fun.

So I have an LB loom on the Allora, x1/9 headlamp motors and not sure how to wire them up. Have read about the diodes and have got some ready however can I do the following…

Have a new 12v supply, two relays on each side just triggered by if side lights are on or off? I figured one relay would give 12v to up/down signal and second relay to provide the earth grounding on the motors to stop them.

Really not in any way into electronics so if you can help please keep it really basic!

Thanks

James