Help needed

[ProtoTipo]

Peter,

I managed to take the gearbox out of my Hawk on my own, to replace the clutch plate.
The engine was supported on a spare wheel and a block of wood.

I refitted it with the aid of some Fiat/Lancia conversion wheel studs, screwed into the bolt holes ('same thread M12 1.25)

[ChrisCar6]

I too have single-handedly removed the gearbox from a Hawk to change the clutch. Being more sophisticated, I used a trolley jack to support the engine. Engine crane took the weight of the gearbox and I also used studs to assist realignment. IIRC all the engine connections remained, as did the wishbone/hub.
It were a right bugger of a job being singlehanded, but doable.. Swearing helped a lot.

[Allora#2]

"it were a right bugger of a job being singlehanded, but doable.. Swearing helped a lot.
Attached Images Attached Images"

i can help only with pictures! but it works without take out the engine