Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Hawk Wiper Arm and Blade

  1. #11

    Re: Hawk Wiper Arm and Blade

    Re the blade itself, I have fitted a 20” supplied by ‘Vipa’, very flexible, more supports along the blade itself which help with fitting the curve at the extremities, and no skidding.
    "Why make it easy when you can struggle"

  2. #12
    SEC Member
    Join Date
    Oct 2011
    Location
    Woodbridge, Suffolk
    Posts
    288
    Rep Power
    14

    Re: Hawk Wiper Arm and Blade

    Quote Originally Posted by hollytree View Post
    Thanks
    Do you think a drill bit could be run through between the teeth that grip the spines so the top nut on the spindle could then be used again.

    Should this info be posted in the alternative build parts section

    Regards
    Steve

    You could drill the cover to accomodate the bolt but I think you would have to fit some sort of IVA compliant nut. I will dig out the arm and post a pic.

    Peter

Similar Threads

  1. Hawk Top Arm Bushes
    By ByrneEngineering in forum Hawk Cars
    Replies: 9
    Last Post: 19-11-2019, 13:39
  2. Wiper Motor Arm and Wheelbox
    By ProtoTipo in forum Technical Common
    Replies: 64
    Last Post: 13-05-2015, 17:29
  3. Wiper Arm
    By The Slug in forum Original and alternative parts to build the cars
    Replies: 0
    Last Post: 07-06-2013, 15:17
  4. Rotor Arm Replacement - 3.0ltr 12V
    By ][\/][ajor in forum Alfa V6 Engine and Gearbox
    Replies: 1
    Last Post: 11-08-2012, 19:48
  5. Wiper arm
    By catswhiskers in forum Hawk Cars
    Replies: 48
    Last Post: 18-02-2012, 20:52

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •