Reply With QuoteI reckon it will go for more than the estimated ?10-20k.
For anyone who would like to build a Tin car like Gerry’s one!
No connexion with the seller!
https://rmsothebys.com/en/auctions/p...arbox/1339943/
Last edited by Stratie.fr; 10-03-2023 at 09:35.
I reckon it will go for more than the estimated ?10-20k.
I doubt it Peter.Originally Posted by Stratos Fear
A good engine and box is about ?35k tops, and can you see a crankshaft, connecting rods and pistons in the photos?
There's got to be a good reason why it's in pieces, too.
And 20% buyer's premium too....that's an expensive pile of bits!
My best guess would be London, but the storage facility is not disclosed.
Then + 10-25K to rebuild it
One I rebuilt 3 yrs ago. from a pile of scattered parts, not all in same series, so bit of a mix match, as there 3 series on 2.4 + the earlier all alloy 2.0
A new distributor cost 3k from Ferrari
Then + 10-25K to rebuild it
One I rebuilt 3 yrs ago. from a pile of scattered parts, not all in same series, so bit of a mix match, as there 3 series on 2.4 + the earlier all alloy 2.0
A new distributor cost 3k from Ferrari
Great job! It Looks very nice!
Last time I have seen one like yours for sale it’s was around 40k!!
Last edited by Stratie.fr; 10-03-2023 at 18:58.
Exactly.....
The majority of the value in this lot, is the transmission. The engine, less so.
'Just had a closer inspection of these Dino parts:
There is only one Lancia Stratos in the world with an outer bell housing like the one in this collection.
The cast iron block for sale is a Fiat Dino block, not a Ferrari Dino block. They are almost identical, but the Fiat block has four threaded holes where the Ferrari block has clearance holes.
Posting Permissions
Bookmarks