wanted build/IVA wheels 5 stud 112mm pcd

[m8kwr]

Does anyone have a set of 5 stud 112mm PCD lying about gathering dust?

I am after a set for build purposes and to get through IVA!

[Darkspeed]

What sort of thing you after?

I have these sitting up the barn doing very little at the moment - 17" x8 ET 20 and ET40 I think - Probaly fit an Alfa Corse I okay They needed spacers on the rear for my Honda I - Tyres hold air and good for rolling around on and they have tread - but thats about all




About the best shot I have of clearance on an LB shell - Rears would be further out in the rear arch on the Alfa Chassis

[Guy Mayers]

Errrrrmm - Matt - are you changing the wheel hubs/brakes? You've got 5 stud 98mm PCD!

Guy

[m8kwr]

My original shell/wheels I have stick out just a little bit. The fronts are fine, but would prefer to look kind of proper and have all wheels the same.

But I do like the wheel sticking out of the arches look.

I think I might still have the same problem with the ET20, since the manual specifies an 8" zero offset on the rear!

I do have the extended rear arches, but was trying to avoid doing any major bodywork changes until after passing IVA, as I am still unsure if I am going to go that direction.

If I can get at least a 9" underneath the rear, which I think should be possible then I will not bother.

[Guy Mayers]

My bad - thought this was Matt's car! Soz!

[hollytree]

watch out for IVA

[hollytree]

[Darkspeed]

ET20 are 20mm inset from Zero - Have you measured up to know what front space you can live with?

9" on a Stradale Alfa I - Probably need ET50 !

[m8kwr]

Sorry I was getting ET20 confused with negative, or it was moving the wheel out of the arch.

So if an 8" wheel with a ET20 fits with 5m to spare, then technically a 9" with an et of 50 should/might!

Thanks for those IVA pages. I knew about the 2nd one, the Annex I had not read that before.

My assumption is that I will fail the first attempts, get the list of failure points and then fix and re-test. With the hope that the problems can be resolved easy enough

[Darkspeed]

Best just measure the distance hub face to arch and do the Math - If staying with Stradale arches you will likely be lumbered with FWD offset looking wheels.